Finally got around to connecting my Autoprom to an eec-iv (Mondeo 2.0l DEEP ecu) today and encountered two problems.
1) Verifying the binary upload always failed when the F1 adapter was connected to the Autoprom but verified OK when it wasn't, is this normal? Do you have to upload first and connect the F1 after?
2) When I started the engine in emulation mode the cooling fan came on constantly and the car ran at about 2/3 normal idle rpm.
I'm using an usb Autoprom with v2.5 firmware, a F1 v1.5 J3 adapter and TunerProRT v4.00.3554.00
These are good questions for Craig. I have zero experience with his Ford products (TunerPro does not yet formally support Ford, but it will in a near future release).
***************************************
TunerPro Author
1989 Trans Am