Anyone know where to get?

BlackBird · Post by **BlackBird** » Mon May 19, 2003 9:05 am

I need an ECM file for a 1228746 Program ID $61. Anyone seen one of these? I looked on DIY-EFI and never found it.

Thanks

Post by **Mangus** » Wed May 21, 2003 7:59 am

you might try posting at the thirdgen.org DIY-PROM message board. Someone might have created one.

BlackBird · Post by **BlackBird** » Wed May 21, 2003 10:18 am

I found one from JPrevost on DIY-EFI. Man, that guys ROCKS!

Thanks though.

jimmichael · Post by **jimmichael** » Mon Sep 15, 2003 12:46 pm

Hi everyone, I am new to this forum but am desperate to find an 8746.ecu file for use with the GMECM Edit software. ANyone know where to locate it. THE DIY_EFI site is no longer up.

Thanks

Jim

Showkilr · Post by **Showkilr** » Fri Sep 19, 2003 10:01 pm

Same Boat.. DIY-EFI looks like its trying to be restored... but needed the ECU file for the $A0.... Truck doesnt run right with the new motor and hunting season is just around the corner... Next weekend to be exact.. Kinda need my truck going..

Post by **Mangus** » Wed Sep 24, 2003 2:07 pm

DIY-EFI should be up again soon.

You might try asking at the thirdgen.org boards if anyone has one.

Dewey316 · Post by **Dewey316** » Mon Dec 22, 2003 11:03 am

i have a really good one i can send to mark, if he would like to put it up on the ECU download list.

Post by **Mangus** » Mon Dec 22, 2003 12:13 pm

please do.

Dewey316 · Post by **Dewey316** » Wed Dec 31, 2003 4:48 am

Mark,

what is an e-mail address to send it to?

Post by **Mangus** » Wed Dec 31, 2003 12:37 pm

click the email button below.

Dewey316 · Post by **Dewey316** » Mon Jan 05, 2004 11:24 am

you only have Profile and PM

Post by **Mangus** » Mon Jan 05, 2004 11:25 am

oh. sorry.

Dewey316 · Post by **Dewey316** » Mon Jan 12, 2004 5:15 am

e-mail sent.

TunerPro User Forum

Anyone know where to get?

Anyone know where to get?

Need an 8746 ECU file