Eec-IV Datalogging

codedout · Post by **codedout** » Tue Aug 08, 2006 3:22 pm

Will there ever be datalogging support for Eec-IV IE T4M0 and J4J1 processors. It would be even nicer to be able to output to Eec Analyzer. This I would pay for.

Post by **Mangus** » Tue Aug 08, 2006 4:47 pm

I don't know of any way to datalog EEV-IV without additional hardware piggybackked off of the ECM. Hardware isn't my bag. =(

Post by **dex** » Wed Aug 09, 2006 12:29 am

Assuming someone could come up with the hardware, what interface with the pc would be required and what information on the eec's data output would be required?

Post by **Mangus** » Wed Aug 09, 2006 9:25 am

The interface would depend on the hardware. It could be serial or USB/VCP. The data would be the typical data you'd expect from the ECM - i.e. all monitored sensors and interesting calibration data (target idle, target AFR, etc).