Injector Flow Rate

91DropTopTA · Post by **91DropTopTA** » Wed Aug 11, 2004 10:07 pm

This is a pretty simple question, but I wanted to be sure that I'm doing this correctly. To change my injector flow rate I use the + - keys to get the final number I need. In this case the hex goes from 443B with .58 calculated to 01A7 with 24.02 calculate. Am I reading this right? I need an injector flow of 24.

Post by **Mangus** » Thu Aug 12, 2004 3:31 pm

Just set the view mode to calculated, hit 24, and hit save!

What you outline doesn't sound correct. Incrememting 443B one more should result in 443C.