vw motronic me7

ares650 · Post by **ares650** » Thu Jul 28, 2011 9:42 am

Hello....I am New Here! Trying to get started on reading and editing my ECU file. I have an 04 VW r32. (its a 3.2 vr6) with a VW Bosch Motronic ME7 ecu.
What cables, editors, would i need. What would the correct steps to read and mod the bin file be.

Thanks for your help.

cdx2k1 · Post by **cdx2k1** » Thu Jul 28, 2011 10:02 am

Im fairly new to this, but this is where I got started:

*Introduction to ECU Programming*
http://www.sciroccovw.com/2009/08/intro ... ogramming/

*Mike Delaney's ECU Basics you should know*
http://www.sciroccovw.com/2009/08/mike- ... ould-know/

Give both of them a read, they offer suggestions to softwares and hardwares to use.Also check out the TunerPro Whitepapers and Tutorials...

ares650 · Post by **ares650** » Fri Jul 29, 2011 8:25 am

lol....thanks for those two links.

So i found out that (a) I need NefMoto ECU Flashing Software http://nefariousmotorsports.com/forum/i ... itle,.html to download and flash the ecu with new files. The questions is how do i know witch memory layout do I use for the flashing?

Then (b) to edit the map I will use TunerPro. But TunerPro will need a definition file (.XDF) for the ECU file. How do i make or find that definition file?

And last (c) whats the deal with the checksums?

Thanks again

cdx2k1 · Post by **cdx2k1** » Fri Jul 29, 2011 8:31 am

NefMOto looks pretty neat!Can't help you with the memory layout..I'm currently trying to learn how to make .xdf's myself but I hit a brick wall.I put a post up here but no response.I'm trying to .xdf a '09 VW 1.4TSI Twincharger ECU File.Checksums are used to check the accuracy of data after it's reached it's destination I think..to ensure data was xfered correctly and not corrupted