I am trying to program a chip for a 7747 ecm. I am not sure about a few things. I have the G2 adapter from moates to utilize the at29c256 chip.
1. I am using the 747-mine.ecu file (this is the only .ecu file I could find for this ecm). Is this correct file?
2. In bin stacker, should I set the bin, chip, and block sizes all to 4k?
3. I need to set the start adress in hex 007000 for the chip, correct?
4. Should I set the buffer adress at 007000 also?
That is all for now.
Thanks in advance,
Jared
Novice questions
Moderators: Mangus, robertisaar, dex
If you stack, set the chip size to 32k, block size to 32k, and bin size to 4k. If stacked, when burning, start at offset 0 for both the buffer and chip.
If you dont want to stack, burn the raw 4k bin to the chip starting at $7000.
M
If you dont want to stack, burn the raw 4k bin to the chip starting at $7000.
M
***************************************
TunerPro Author
1989 Trans Am
TunerPro Author
1989 Trans Am
-
- Posts: 8
- Joined: Wed Jan 12, 2005 4:15 pm
- Location: ISU
- Contact:
'51 Ford F-6 Dually Dumptruck/'72 Cheyenne20/'59 VW Chassied Buggy/'85 Honda Prelude/'91 Nissan Maxima
Check out my site at Http://www.speedyoldtruck.com
Always looking for Caddy N* information, working on a tunable OBD1 ECU.
Check out my site at Http://www.speedyoldtruck.com
Always looking for Caddy N* information, working on a tunable OBD1 ECU.