cant figure out how to add bitmasks
i dont understand, like in tunerpro rt aldl editor you put in the address
then put in the bit
in scannerpro there is operations?wtf
say i want to add the following, how would i go about doing it....
0x1 = bit 0
0x2 = bit 1
0x4 = bit 2
0x8 = bit 3
0x10 = bit 4
0x20 = bit 5
0x40 = bit 6
0x80 = bit 7
so, for 4th gear flag, set the offset to 58 (0-based), Bitwise AND, operand is 0x04, and result is 0x04. This is the same as saying "if the data at offset 58 is ANDed with 0x04 and the result is 0x04, then the flag is set, otherwise it's cleared".
alrighty, thanks for clarifing
was confused when i was looking at the 8d adx and seen values like 3c ect..
so when i compared that to the a100 aldl stuff it didnt match the address and i got confused lol