I would like the ability to paste cells from exell into columns and rows...or be able to type in one value at the top....and the next lower cell make an equation like =(1st cell)+5
I have a table in my car that is 32 rows.....the rows are degrees in celcius....from -45 to 110 in increments of 5 degrees
entering 32 values takes a while
In excell it took 2 seconds...but I can't past them in...
or I would like to pick a single value at another address (my 110 degrees celcius) and tell tuner pro that the 110 is the last row....make increments of 5 celcius down to -45....
something along the lines of that....
paste cells in excell to columns and rows
Moderators: Mangus, robertisaar, dex
-
- Posts: 15
- Joined: Thu Jun 29, 2006 9:57 am
paste cells in excell to columns and rows
Twin Turbo 300zx
-
- Posts: 15
- Joined: Thu Jun 29, 2006 9:57 am
for labels in columns and row
in the actual tables I use the crt+c or v....but I'm talking about for labeling rows and columns in the XDF editor...when you click on row or column....set the number of rows or columns and then set to string + manual......I couldn't paste in my row labels in the xdf editor from excell...i'll try again....
Twin Turbo 300zx
-
- Posts: 15
- Joined: Thu Jun 29, 2006 9:57 am
cool
yup now we're on the same page I have to do 32 manual values....excell took me 5 seconds.....each one...will take some time
Twin Turbo 300zx