1994 Trans Am GT $EEb cant create a good bin

Sledgehammer007 · Post by **Sledgehammer007** » Sat Jul 07, 2007 12:01 pm

I can read and flash a stock bin to my Trans Am. I am using the latest version of Tunerpro RT and the latest EEb definition file. Every time I try to flash my custom file i get a rapid flashing check engine light with my fans on full blast. When i flash the stock one back everything goes back to normal.

I even just tried making little changes and that dosen't work ether.

I chose the EEb definition file because EE shows 0 for cylinder volume. and EEb shows 717.25

what is the deal here am i missing something

I even tried pulling the battery to reset the computer for 5 min.

Post by **Mangus** » Sat Jul 07, 2007 1:02 pm

Try disabling the checksum (change the 'EE' mask ID byte to 'AA').

Sledgehammer007 · Post by **Sledgehammer007** » Sat Jul 07, 2007 2:27 pm

Mangus wrote:Try disabling the checksum (change the 'EE' mask ID byte to 'AA').

I don't really understand what that means. am I looking for the mask ID byte in the hex editor?

I didn't see that in the list of avalible tables.

Sledgehammer007 · Post by **Sledgehammer007** » Sun Jul 08, 2007 12:25 pm

Well i thought i found it but I must not be doing something right

I gave myself a crash course on hex to find the mask ID but the bin still dosen't work in the car.

Post by **Mangus** » Sun Jul 08, 2007 12:51 pm

Sledgehammer007 wrote:Well i thought i found it but I must not be doing something right

I gave myself a crash course on hex to find the mask ID but the bin still dosen't work in the car.

email me your bin.