Binary View

[bubba2533]

It would be helpful to be able to see a table of bits. I think it would be pretty easy to just show the data in binary as well as decimal and hex.

Right now the only way I see is to do it with individual flags, but it's a table of cylinder enable/disable flags, so that would be quite a bit of individual flags.

[Mangus]

Thank you for the suggestion.

[darkcorp]

Yes, this improvement would be very useful. It would be great to put the large list of configuration flags into a single table.
Or implement a function that will indicate a particular value corresponding to a bit mask.

[Mangus]

Or implement a function that will indicate a particular value corresponding to a bit mask.

Can you give me an example of this, or describe how you would want this to work and look? As you describe it (or the way I interpret your description), you could do this with an equation today.

[darkcorp]

Hi, Mangus!

Thanks for immediate reply.

For examle,

Code: Select all

ENGINE CONFIGURE (RMB 1)
BIT ASSIGNMENTS
0080   V8_59
0040   (SPARE)
0020   V10
0010   V8_52
0008   I4_25
0004   25_DIESEL
0002   V6
0001   I6

At this point there are 8 Flags on single Config parameter only that are hard to check one-by-one.
Is there an easier and more user friendly way to monitor such type of information?

BTW where can I learn about formulas that are supported by TunerPro?

[Mangus]

I don't understand why XDF flags don't work for this. This is exactly why they exist.

[darkcorp]

XDF flags definitely work when you have a couple of them.
In my case configuration has 11 bytes and each 8 bits, so my parameter tree is very long (on the screenshot you see only 4 configs)

[darkcorp]

you could do this with an equation today.

Mangus, could you please give me a hint how to do this with an equation please?