Hi All,
I am new to Tuner Pro for OBD2.
I have a 2000 TA LS1 which I would like to flash for changed rear gear ratio.
Is there a list of compatible USB OBD2 adapters which I can purchase?
Thank you,
Pat
2000 TA LS1 Flashing - Is there a list of compatible USB OBD2 adapters?
Moderators: robertisaar, dex
Re: 2000 TA LS1 Flashing - Is there a list of compatible USB OBD2 adapters?
No, I will install the 3.42 gears into the axle.
My current gear ratio is 3.23 and I will swap in a gear set for 3.42.
The question of flashing the system for the new gear ratio.
Will there be any specific areas in the BIN which will require changes besides the "Final Drive Ratio" ?
My current gear ratio is 3.23 and I will swap in a gear set for 3.42.
The question of flashing the system for the new gear ratio.
Will there be any specific areas in the BIN which will require changes besides the "Final Drive Ratio" ?
Re: 2000 TA LS1 Flashing - Is there a list of compatible USB OBD2 adapters?
I think its mostly for correcting speed info into digital bus
Trans itself working based on speed sensor that count prop shaft revs and not wheels
Trans itself working based on speed sensor that count prop shaft revs and not wheels