Moto Guzzi Marelli 38M3G ecu tuning NEW TunerPro XDF.

[OldSkullTuning]

New TunerPro bin definition files (xdf) series for Moto Guzzi with ecu Magneti Marelli MIU M3G (also called 38M3G or 38M3G3).

Some of the supported motorcycles:

Moto Guzzi V7 750
Moto Guzzi V9 850

Available the most relevant engine maps like main spark advance, spark advance corrections, main fuel (lambda), fuel corrections, torque, idle engine speed, rpm limiters, etc.

Price 60 euro.

Post: https://oldskulltuning.com/moto-guzzi-r ... -tunerpro/

[Ralf013]

Dear Oldskull Team,
I just bought a brand new MotoGuzzi V7 850 E5 Year 2021 and later; Type "KZ". Mapping setup seems to be very "lean" at low loads and rev's....

The ECU Type is Marelli "MIU G4"

I understood that there is no "K-Line" connection" for readout anymore, but a CAN bus connection is required instead (?)
Question:
Any idea about the availability of an XDF/ADX for such ECU?
What hardware/software is needed to get appropriate access via CAN bus and use Tunder Pro for reading/writing?
(I have some good experience with Tuner Pro with my earlier Buell XB12, MY2008, but this was easy access to ECU)

Thank you very much from good old Germany
With my best regards
Ralf