TunerPro User Forum

Bump

Thanks 89. Actually, it an 86 suburban that was originally Carbureted, then i coverted to TPI, using an inline TPI pump. my problem is a base tune to use until I can get my hands on a notebook, to do some datalogging while driving. The reason I say the truck is an 87, is that I have the 87-95 swirl ...

Ok, I have been trying to at least get a good base tune for the tpi 350 in this truck(730 ECM), with no success. I don`t know if I am copying tables over wrong(Copying and manually entering TBI Van, or truck tables($0d) to the 8d tpi chip) I am using APU1, but I know somebody must have a TPI Bin for...

Ok, So, i have followed the provided instructions that came with my APU1 set. Also used the HELP section on Tunerpro RT, followed those directions (same as the "Getting Started" card with Moates) and have had no success in emulating. When I load a BIN, I can view it, using the yellow link ...

Thanks! The donor vehicle was an L98. The long block is basically an 87 to 95 TBI truck engine. I`ll give those bins a shot.

Ok, first off, my vehicle is a 1986 Chevy Suburban 5.7(350, LS9), Running TPI (730ecm), Recently installed 193 swirl port heads, and a compucam 260 camshaft. 700r4 Trans. Last week, I purchased APU1, and have TunerproRT installed. Wrenching with computers is new to me, and I dont Know where to start...