Bosch Motronic red label 402 DME(need help getting started!)
Posted: Tue Jan 09, 2018 12:50 am
Hi everyone!
I have been searching around trying to find the proper XDF's and BIN's for my red label 402 DME, the only 402 files I found on the TunerPro downloads page are for a 402 silver label DME?
I'm know that the 403/405 is cross platform however the 402 is not. Could anyone please PM me the correct files to get started or should I swap the DME to another version? (it was out of a 92 325i however theres a possibility it could be swapped)
P.s Has anyone here tinkered with the non-vanos hotwire maf? People have suggested installing it in a larger diameter tube to shift the point in where it reads, although this gives rough idling down at low rpm, could this be something that a tune could fix or will the ecu always fight to correct values in these circumstances?
I have been searching around trying to find the proper XDF's and BIN's for my red label 402 DME, the only 402 files I found on the TunerPro downloads page are for a 402 silver label DME?
I'm know that the 403/405 is cross platform however the 402 is not. Could anyone please PM me the correct files to get started or should I swap the DME to another version? (it was out of a 92 325i however theres a possibility it could be swapped)
P.s Has anyone here tinkered with the non-vanos hotwire maf? People have suggested installing it in a larger diameter tube to shift the point in where it reads, although this gives rough idling down at low rpm, could this be something that a tune could fix or will the ecu always fight to correct values in these circumstances?