Posted: Tue Jun 14, 2016 6:28 am Post subject: Why Tunerpro v5 doesn't read the correct addresses?
I'm trying to understand why with a bin with addresses from 0 to 8000, Tunerpro reads only if you put....addresses STARTING from 8000
I mean, Tunerpro read not values at 0DD0 (for example) where the value IS, but only if you put the address as 8DD0.
For example...that address is the "turbo duty cycle" 4x16 table.
If you put the correct address of 0DD0, the program reads 00 for all the values.
You have to put the address as 8DD0 to make the program reading.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum