730 $A1 mask Lean Cruise issue

mswenson289 · Post by **mswenson289** » Sat May 15, 2010 5:38 pm

I am running a 7730 using a $A1 mask, Attempting to turn on Lean Cruise Mode 06C3 bit 7. After making the flag set and saving the bin. I burn the chip and reinstall in the ECM. Try connecting using ADL and will not communicate. Go thru the whole process again only turning off the flag and all is happy. With the bit set doing a compare bin with the non set bin. Compare does not note any differences. Could this not be the correct location or is there something else going on? I have searched and found nothing. Going on a long road trip tomorrow and would like to try and bump the MPG a little. Any ideas?
Mike

Post by **robertisaar** » Sat May 15, 2010 7:05 pm

using my XDF, i have no problems enabling/disabling lean cruise and still keeping ALDL working...

http://robertisaar.co.cc/web_images/my%20A1.7z

http://robertisaar.co.cc/web_images/A1.7z

try those and see what you get.

mswenson289 · Post by **mswenson289** » Sun May 16, 2010 3:07 am

Thanks, maybe i will/ should start over with a clean plate.
Mike