Cant Get Def File To Matchup
Moderators: robertisaar, dex
Cant Get Def File To Matchup
I am tuning my first EECV AOL3 CRAJ 98 Cobra and cannot get the bin to line up with the def to save my life.The def I have says a 128k file but I see some people on Moates are using a full 256k file.I have played with the offset and some things will look correct like the fan on/off temps but the inj slope is wrong.HELP
Also what are the burn1 addresses for burning a Moates F3 chip?
I am assuming if I am using a 256k file it would be 000000-03FFFF.
Thanks
Also what are the burn1 addresses for burning a Moates F3 chip?
I am assuming if I am using a 256k file it would be 000000-03FFFF.
Thanks
If you used either TunerPro or Flash&Burn to extract your bin with a start address of “000000” and an end address of “03FFFF” for both the ‘chip’ and ‘buffer’ addressing then the bin will already be padded.
If you have a 216k bin then you need to use a hex editor to insert 8192 bytes at the start of each bank and at the end of bank 1 to 'pad' the bin out to 256k.
If you have a 216k bin then you need to use a hex editor to insert 8192 bytes at the start of each bank and at the end of bank 1 to 'pad' the bin out to 256k.
This is the 256k that I pulled from the ECU.
Maybe the def is just incomplete or something.Some of the valves look right but for example the inj slope is wrong but the rev limits and fans look right.
http://www.staplesautoengineering.com/Files/AOL3.bin
Maybe the def is just incomplete or something.Some of the valves look right but for example the inj slope is wrong but the rev limits and fans look right.
http://www.staplesautoengineering.com/Files/AOL3.bin