not a great thing...
when I switch to 'compare bin' in wireframe and switch back to normal graphic view from this mode, I can't mark any point.
No matter if its shown in color whether wireframe.
I must close the window/graphik view and reopen it.
Then it mostly works again and I can mark and change points.
with best regards
Bernhard
small bug in graphic view
Moderators: Mangus, robertisaar, dex
I just tried to reproduce it, and... it works.
until I tried to load a fresh .bin into the comparelist and highlight it.
then things happened like my description.
clicking the wireframe, and the marking point disappears.
and was lost in open spaces of RAM
a minor bug, and only a 'specialist' like me will find it.....
with best regards
Bernhard
until I tried to load a fresh .bin into the comparelist and highlight it.
then things happened like my description.
clicking the wireframe, and the marking point disappears.
and was lost in open spaces of RAM
a minor bug, and only a 'specialist' like me will find it.....
with best regards
Bernhard
Thx.
I hope, that not a special hardware/software constellation on my pc was the reason. (and you tries it in vain )
the strange disappearing only happens, when i load a new .bin in the comparelist. mostly i've used only one to compare.
apart from this, TP is a really, really fine program
with best regards
bernhard
I hope, that not a special hardware/software constellation on my pc was the reason. (and you tries it in vain )
the strange disappearing only happens, when i load a new .bin in the comparelist. mostly i've used only one to compare.
apart from this, TP is a really, really fine program
with best regards
bernhard