Mefi 4 what does ccp stand for n car stumbles at 190 f help

Discuss anything TunerPro related.

Moderators: Mangus, robertisaar, dex

Post Reply
Joe509irocz
Posts: 5
Joined: Wed Jul 10, 2013 12:26 pm
Location: Matawan N.J

Mefi 4 what does ccp stand for n car stumbles at 190 f help

Post by Joe509irocz »

I have a problem since I put the mefi 4 unit in I had a 3 with no problems but now when my ect is around 190 f the car startes to stumble but never really dies but once it gets down to 180 f it's fine thinking its the mat but also wanna know what the ccp stands for
robertisaar
Author of Defs
Posts: 962
Joined: Sat Feb 21, 2009 3:18 pm
Location: Camden, MI

Post by robertisaar »

CCP = carbon cannister purge.
Joe509irocz
Posts: 5
Joined: Wed Jul 10, 2013 12:26 pm
Location: Matawan N.J

Post by Joe509irocz »

What the hell is that for n as far as the problem with my car stumbling its looking like my inj. R going wide open then I get a low tps malf
Drag radial bbc 509 with NX NITROUS SYSTEM with twin gt4508 r's going on
robertisaar
Author of Defs
Posts: 962
Joined: Sat Feb 21, 2009 3:18 pm
Location: Camden, MI

Post by robertisaar »

carbon cannister = emissions item. captures gasoline vapors that form in the gas tank, get stored in the cannister until the ECM commands on a solenoid that allows those vapors to be drawn in by the engine and burned.
Joe509irocz
Posts: 5
Joined: Wed Jul 10, 2013 12:26 pm
Location: Matawan N.J

Post by Joe509irocz »

Don't think that's going to have any affect on my problem but ill turnip off any how
cbernhardt
Posts: 95
Joined: Fri Apr 18, 2008 5:19 am

Re: Mefi 4 what does ccp stand for n car stumbles at 190 f h

Post by cbernhardt »

Joe509irocz wrote:I have a problem since I put the mefi 4 unit in I had a 3 with no problems but now when my ect is around 190 f the car startes to stumble but never really dies but once it gets down to 180 f it's fine thinking its the mat but also wanna know what the ccp stands for
Does the engine idle correctly when the temp is 190F?
Is the 190F reading from a gauge or from scanning software?
Joe509irocz
Posts: 5
Joined: Wed Jul 10, 2013 12:26 pm
Location: Matawan N.J

Post by Joe509irocz »

Looks to be electrical not sure because when I thought it was at that temp only the more I work on it it seems to be intermittent slowly but surely I'm thinking a bad ground off the harness goin to look at it tomorrow
Drag radial bbc 509 with NX NITROUS SYSTEM with twin gt4508 r's going on
Post Reply